Cold spraying—an effective shapable method for preparing high-performance Bi2Te3-based thermoelectrics

Document Type

Article

Publication Date

11-1-2026

Abstract

With the advantages of material-saving shapable production and facile geometry design, shapable methods provide a broad prospect for the future thermoelectric material production. Herein, cold spraying followed by annealing (CSA) induces enriched defects in the bulk material, which can lead to excellent thermoelectric performance and hardness. Compared with the HP process, CSA contributes to more pores and intrinsic defects. The enriched intrinsic defects contribute to moderate electrical performance. Simultaneously, these defects strongly scatter phonons, leading to ultra-low total thermal conductivity values of ∼0.64 W m−1 K−1 for both p-type CSA Bi0.5Sb1.5Te3 and n-type CSA Bi2Te2.7Se0.3 bulks at room temperature. Correspondingly, CSA bulks possess excellent room-temperature zT of ∼1.1 (p-type Bi0.5Sb1.5Te3) and ∼0.9 (n-type Bi2Te2.7Se0.3), respectively, which are comparable to those prepared by HP and other shapable methods. Furthermore, a four-leg thermoelectric device is assembled based on as-prepared p-type CSA Bi0.5Sb1.5Te3 and n-type CSA Bi2Te2.7Se0.3 bulks, achieving a rational energy conversion efficiency of ∼4% under a small temperature difference of 100 K. This study demonstrates CSA method is promising for future shapable production of high-performance thermoelectric materials.

Keywords

Bi2Te3, Bulk, Cold spraying, Shapable method, Thermoelectric

Publication Title

Journal of Materials Science and Technology

ISSN

1005-0302

DOI

10.1016/j.jmst.2026.02.001

Volume

270

First Page

305

Last Page

312

Share

COinS