Fixed angle lifting approach: A feasible and effective coating method for preparing long range order polystyrene monolayer with controllable optical property

Document Type

Article

Publication Date

2-1-2026

Abstract

Colloidal lithography of polystyrene (PS) microspheres monolayer offers a low-cost and scalable route for photonic application. However, traditional transfer process suffers from poor uniformity and limited reproducibility. Herein, an improved strategy called fixed angle lifting process to produce high quality monolayer is proposed. By precisely fixing the substrate tilting angle onto a wire followed by transfer the PS assembled to the substrate, a highly uniform PS monolayer is obtained. The quality of monolayer is found to dependent on lifting angle according to FESEM and FFT analysis, where 45◦ lifting angle yields the highest PS coverage (91.68 %). Total reflectance analysis reveals the periodical interference pattern that is well-correlated to the simulation data. The full width at half maximum (FWHM) calculation on the highest intensity interference peak (~900 nm) is found to have direct correlation with the overall uniformity of the monolayer. Different interference peak position is associated to the incident wavelength characteristic that strikes on different sites of the monolayer. This is proven by samples that underwent plasma-etching, where an obvious diminishing of interference pattern intensity is observed. Further characterization by atomic force microscopy (AFM) and FDTD simulations supports the observed optical behavior and structural integrity.

Keywords

Interference, Monolayer, Photonic crystals, Polystyrene, Reflectance, Self-assembly

Publication Title

Optical Materials

ISSN

0925-3467

DOI

10.1016/j.optmat.2025.117704

Funders

UMQIST, UM Centre of Excellence for Quantum Information Science and Technology, Ministry of Higher Education, Malaysia (FRGS/1/2022/STG07/UM/02/4)

Volume

170

Publisher

Elsevier B.V.

Share

COinS